Our customer provided us with an imported sample nut and asked if we could get close to the product they wanted. The finish on their product was absolutely terrible - and the thread wasn't even...
12 yes TWELVE slots on a nut so small... Yes, we machined them with accuracy, ease and speed. These type of slotted nuts tend to go on parts where a degree of fine rotation is needed in...
All fastener standards have specific sizes which are commonly used. However, from time to time, non preferred sizes come into play. When the original fastener sizes were being standardised...
Slotted nuts are often called castellated nuts. They have slots cut into one side. Typically there are a total of 6 opposing slots, but this number can vary - in very large nuts 8 are common, as...
Whilst making bolts, setscrews and other externally threaded rods is not our speciality, we still managed to precision machine these 3.5 inch long (under the head) hexagon set screws in bright...
In a cost saving exercise for our customer, we manufactured 4 pieces of the unified to metric threaded hexagon connector nuts. Our customer wished to use a brush head on a device that came in...
We recently manufactured a small batch of just 10 flange nuts out of naval brass for one of our customers. Smaller quantities are not an issue and as you can see, the quality is exceptional.
It took us just 2 hours to make a small batch of these cap nuts to our customers sample. He didn't know what thread was being used and he found the cap the sample he had wouldn't go all the way....
A customer asked us to prototype an adaptor of theirs to join two incompatible parts, one with a metric M12x1.75 female thread and the other part with a male 1/2x12tpi BSW thread. We said no...
We were provided with a customer's drawing and a sample to work from on this part. It involved a number of different processes, and ensuring the finish was right was key to this...
